Ciscos don't work w/ KarlNet
we've got a 100mW prism card w/ 2 connectors on it - but we're happy just
using on of the two
pricing is pretty good too
-Charles
-----Original Message-----
From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
Behalf Of Leszek Olszewski
Sent: Tuesday, June 04, 2002 10:49 AM
To: karlnet@WISPNotes.com
Subject: [Karlnet] Prism2 cards
Hello,
Is there a Prism2 card that works with Karlnet, has two antennas connector
and allows separation to connect transmit antenna on one connector and
receive to the other? Cisco cards allow that but when I tried booting
RG-1100 with one it just hangs. On the other hand it boots fine with
Netgear and Proxim cards which I believe are Proxim2. None of them allows
signal send/receive separation though (or am I wrong)?
Any suggestions, pretty please? ;)
Regards,
Leszek
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|