RE: [Karlnet] Prism2 cards

[Leszek Olszewski <leszek@oslink.pl>]

That sounds fine but I need to connect two antennas - one with higher gain 
to the receive connector and other with lower gain to transmit connector. 
That is to comply with ETSI rules and 20dBm EIRP power to send, and receive 
with antenna having higher gain. Does your card allow that?

Regards,
Leszek

Excuse all the typos in my former post ;)


At 11:23 2002-06-04 -0500, you wrote:
> Ciscos don't work w/ KarlNet
>
> we've got a 100mW prism card w/ 2 connectors on it - but we're happy just
> using on of the two
> pricing is pretty good too
>
> -Charles
>
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
> Behalf Of Leszek Olszewski
> Sent: Tuesday, June 04, 2002 10:49 AM
> To: karlnet@WISPNotes.com
> Subject: [Karlnet] Prism2 cards
>
>
> Hello,
>
> Is there a Prism2 card that works with Karlnet, has two antennas connector
> and allows separation to connect transmit antenna on one connector and
> receive to the other? Cisco cards allow that but when I tried booting
> RG-1100 with one it just hangs. On the other hand it boots fine with
> Netgear and Proxim cards which I believe are Proxim2. None of them allows
> signal send/receive separation though (or am I wrong)?
>
> Any suggestions, pretty please? ;)
>
> Regards,
> Leszek
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet