Leszek
Our cards work with Karlnet but Prism will only work in TurboCell mode
at this point. Cisco is a proprietary solutions that KN does not
support.
http://www.demarctech.com/products/relia-wave-100mw-prism2-5-pcmcia-card
.html
This card has two MMCX(Male) antenna connectors but it wont do what you
are referring to, TC would need to support this directly.
Sincerely
Tony Morella
Demarc Technology Group
Office: 908-996-7995
Cell: 908-246-9170
Fax: 908-847-0202
email: tony@demarctech.com
http://www.demarctech.com
Wireless Solution Provider
-----Original Message-----
From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
On Behalf Of Leszek Olszewski
Sent: Tuesday, June 04, 2002 11:49 AM
To: karlnet@WISPNotes.com
Subject: [Karlnet] Prism2 cards
Hello,
Is there a Prism2 card that works with Karlnet, has two antennas
connector
and allows separation to connect transmit antenna on one connector and
receive to the other? Cisco cards allow that but when I tried booting
RG-1100 with one it just hangs. On the other hand it boots fine with
Netgear and Proxim cards which I believe are Proxim2. None of them
allows
signal send/receive separation though (or am I wrong)?
Any suggestions, pretty please? ;)
Regards,
Leszek
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|