office wrote:
Hi,
I have two AP1000 running V4.02. The ETH interfaces are directly
connected with an Ethernet cord (no HUB/Switch). On one of the AP's the
"carrier sense error" are constantly increasing (monitoring >
Ethernet-like interfaces). On the other AP1000 the value is zero. Can
you help me ... Means that I have errors on the ETH interface?
Chivu Gheorghita
Hello,
This is a problem that Karlnet denied existence for a very long while.
Upgrade to 4.27 or 4.31 and it will "go away". I am quite sure if you
pull the power to the second unit for a few seconds, you will see the
same behaviour there too.
Chris
|