Bob,
We replaced all of our NDIS clients with RORs about a year ago. The
NDIS clients were such a managerial nightmare, it was a breath of
fresh air to get rid of them. Anyway, when I was able to switch from
"ISP Base" to "Polling Base", we saw an immediate 15-30% increase in
throughput on the AP. We use routing and WEP, I don't know if that
had any bearing on our amount of improvement -- YMMV. The throughput
is improved because the "ISP Base" setting includes more computational
overhead than the "Polling Base" setting.
-Brian
____________________________________________________________
Brian H. Oak CISSP?CCDP CCNP CCA NNCAS Datawav-IS, LLC
Principal Engineer? ?? 109 N. Arthur Ave., Ste. 301
(208) 232-6860???????????????? Pocatello, ID? 83204
(208) 232-0185?fax???????????? ?? ??brian@infosystems1.com
-----Original Message-----
From: karlnet-bounces@WISPNotes.com
[mailto:karlnet-bounces@WISPNotes.com]On Behalf Of Bob Hrbek
Sent: Tuesday, February 11, 2003 09:37
To: Karlnet Mailing List
Subject: Re: [Karlnet] Turbocell Base Station Modes
So, if I'm using only RG's ....is there a disadvantage to the ISP base
station mode? Is it not as good as the "Polling Base"?
----- Original Message -----
From: "Dan Metcalf" <dan.metcalf@wbsysnet.com>
To: "'Karlnet Mailing List'" <karlnet@WISPNotes.com>
Sent: Tuesday, February 11, 2003 10:27 AM
Subject: RE: [Karlnet] Turbocell Base Station Modes
> Bob,
>
> ISP base allows NDIS clients (windows clients).
>
>
> Dan Metcalf
> Wireless Broadband Systems
> http://www.wbsysnet.com/
> 781-577-2780
> dan.metcalf@wbsysnet.com
>
>
> > -----Original Message-----
> > From: karlnet-bounces@WISPNotes.com
> [mailto:karlnet-bounces@WISPNotes.com]
> > On Behalf Of Bob Hrbek
> > Sent: Tuesday, February 11, 2003 11:18 AM
> > To: Karlnet Mailing List
> > Subject: [Karlnet] Turbocell Base Station Modes
> >
> > Can somebody explain the difference between a "Polling Base
Station"
> and
> > "ISP Base Station" ?
> >
> > I understand what polling is and I realize that there is also a
"ISP
> base
> > station w/ protocol filtering" but I was just wondering in what
> > circumstances you would use "Polling Base" over "ISP Base".
> >
> >
> > Thanks,
> > Bob
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
> > ---
> > [This E-mail scanned for viruses by Declude Virus]
>
>
> ---
> [This E-mail scanned for viruses by Declude Virus]
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|