Thanks,
that's what I was looking for.
-bob
----- Original Message -----
From: "Brian H. Oak" <oakb@infosystems1.com>
To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
Sent: Tuesday, February 11, 2003 11:07 AM
Subject: RE: [Karlnet] Turbocell Base Station Modes
> Bob,
>
> We replaced all of our NDIS clients with RORs about a year ago. The
> NDIS clients were such a managerial nightmare, it was a breath of
> fresh air to get rid of them. Anyway, when I was able to switch from
> "ISP Base" to "Polling Base", we saw an immediate 15-30% increase in
> throughput on the AP. We use routing and WEP, I don't know if that
> had any bearing on our amount of improvement -- YMMV. The throughput
> is improved because the "ISP Base" setting includes more computational
> overhead than the "Polling Base" setting.
>
> -Brian
> ____________________________________________________________
> Brian H. Oak CISSP CCDP CCNP CCA NNCAS Datawav-IS, LLC
> Principal Engineer 109 N. Arthur Ave., Ste. 301
> (208) 232-6860 Pocatello, ID 83204
> (208) 232-0185 fax brian@infosystems1.com
>
>
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
> [mailto:karlnet-bounces@WISPNotes.com]On Behalf Of Bob Hrbek
> Sent: Tuesday, February 11, 2003 09:37
> To: Karlnet Mailing List
> Subject: Re: [Karlnet] Turbocell Base Station Modes
>
>
> So, if I'm using only RG's ....is there a disadvantage to the ISP base
> station mode? Is it not as good as the "Polling Base"?
>
>
> ----- Original Message -----
> From: "Dan Metcalf" <dan.metcalf@wbsysnet.com>
> To: "'Karlnet Mailing List'" <karlnet@WISPNotes.com>
> Sent: Tuesday, February 11, 2003 10:27 AM
> Subject: RE: [Karlnet] Turbocell Base Station Modes
>
>
> > Bob,
> >
> > ISP base allows NDIS clients (windows clients).
> >
> >
> > Dan Metcalf
> > Wireless Broadband Systems
> > http://www.wbsysnet.com/
> > 781-577-2780
> > dan.metcalf@wbsysnet.com
> >
> >
> > > -----Original Message-----
> > > From: karlnet-bounces@WISPNotes.com
> > [mailto:karlnet-bounces@WISPNotes.com]
> > > On Behalf Of Bob Hrbek
> > > Sent: Tuesday, February 11, 2003 11:18 AM
> > > To: Karlnet Mailing List
> > > Subject: [Karlnet] Turbocell Base Station Modes
> > >
> > > Can somebody explain the difference between a "Polling Base
> Station"
> > and
> > > "ISP Base Station" ?
> > >
> > > I understand what polling is and I realize that there is also a
> "ISP
> > base
> > > station w/ protocol filtering" but I was just wondering in what
> > > circumstances you would use "Polling Base" over "ISP Base".
> > >
> > >
> > > Thanks,
> > > Bob
> > >
> > > _______________________________________________
> > > Karlnet mailing list
> > > Karlnet@WISPNotes.com
> > > http://lists.wispnotes.com/mailman/listinfo/karlnet
> > > ---
> > > [This E-mail scanned for viruses by Declude Virus]
> >
> >
> > ---
> > [This E-mail scanned for viruses by Declude Virus]
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
> >
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|