I need a flashrom setup to handle a growing cell site. I have about 50
clients on a KN-200 board ( at least I think it is...it's the one with two
PCMCIA interfaces). We upgraded from and AP-1000 when performance was
getting poor and it was NIGHT and day difference on ping times/latency and
user perception of performance.
Well, ping times are getting high again and I was considering replacing the
KN-200 w/ some sort of a flashrom box. I want something small (a little
larger than an AP-1000 would be ok but not much more. I just don't have
room for it.
Will the karlnet flashrom setup run on a routerboard 230 from Mikrotik?
It's a 266Mhz setup and outdoor rated w/ a PCI slot and 2 PCMCIA slots, I
believe. Thoughts?
Thanks,
Bob
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|