Hi
enable bridge on general setup to ... do a bridge (transparent or not)! ;~)
jokes apart, I found this very nice manual at
http://www.demarctech.com/downloads/reliawave-turbocell/demarc-turbocell-manual.pdf
which explains most options on Karlnet Configurator setup
including what change on menus when you select one configuration
option or the other (in your case, bridge x routing)
which I didn't find, yet, is a good routing tutorial on KN Configurator
nor online explanations on how to analise a link (signal etc)
also using KN Configurator. besides many many hints on this list,
of course :-)
hope this helps
!3runo
Aaron Siegel wrote:
> I am trying to configure a transparent bridge with a RG-1000 with SEC
> (SE-4505) installed. In the 802.11b menu I have selected "Mobile
> Ethernet Converter", I think I did, when I reopened the configuration
> the option reads "Mobile Unit". The 802.11 side associates with the
> wireless network, and I am able to ping the device. I am unable to ping
> the wireless network from the ethernet. I do not have any option in the
> general setup, the options Enable Bridge, Enable IP Routing,.. are not
> selected. I am not sure what I am doing wrong.
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|