It always helps to select RADIO1 in the pop-up window after starting NA.
This was the ONLY reason my 990 rig control would not work (except for trying
to run it from COM3 which you will read about below). I guess I just dont
contest enough anymore these days and I have started to miss a few things.
All is working fine now. However, one of my radios needs a firmware upgrade.
Now for the "but"!
But, I am wanting to run this stuff on COM3 and after multiple attempts of
changing irq's and such I have had no luck. I have tried this on a pair of
computers...nil. Here again it may be something simple that I am overlooking.
I have read the archives on similiar issues but I dont seem to be finding the
answers I need.
In my station (main operating position) I use COM1 as the Internet Packet port.
NA thinks the internet computer is nothing more than a TNC. COM2 is used for
the link or loop. It is ok to use COM1 for rig control when I am doing
something where I am not going to use packet...but when we do a multi-op I need
to use COM3 for either the LINK, TNC or RIG.
Input appreciated.
Bob
|