Rob,
I'm afraid I don't have an explanation for you. When I test log a MARP
QSO here, it works fine, both with 10.59 and the recent 10.61, and also
with both the old and new CALCTY.MLT files. (The abbreviation for
Mariposa County - MARP - is the same in both the old and new files.)
Dave/K8CC
Rob Neece wrote:
> I have been inactive for a while and just decided to get on the CQP
> and warm up my CW. I copied the data at the end of the post by David
> Pruett and made two files: CALCTY.MLT and CALCTY.ALI. I'm outside
> CA, so the CALCTY.MLT file is the one I think I need, and it contains
> lines like the following:
> Alameda: ALAM: CTY: 6;
>
> I corrected the ALPI problem, put the file in the proper place, and
> then fired up NA1059. Everything was OK until I made a QSO and tried
> to log MARP. NA indicated the county was not a valid QTH. Alt-L
> shows the expected list of 4-letter counties including MARP, so I am
> at a loss. Where did I go wrong?
>
> Rob
>
>
> _______________________________________________
> NA-User mailing list
> NA-User@contesting.com
> http://lists.contesting.com/mailman/listinfo/na-user
> NA on the web: http://www.datomonline.com/
>
>
>
_______________________________________________
NA-User mailing list
NA-User@contesting.com
http://lists.contesting.com/mailman/listinfo/na-user
NA on the web: http://www.datomonline.com/
|