I have been inactive for a while and just decided to get on the CQP
and warm up my CW. I copied the data at the end of the post by David
Pruett and made two files: CALCTY.MLT and CALCTY.ALI. I'm outside
CA, so the CALCTY.MLT file is the one I think I need, and it contains
lines like the following:
Alameda: ALAM: CTY: 6;
I corrected the ALPI problem, put the file in the proper place, and
then fired up NA1059. Everything was OK until I made a QSO and tried
to log MARP. NA indicated the county was not a valid QTH. Alt-L
shows the expected list of 4-letter counties including MARP, so I am
at a loss. Where did I go wrong?
Rob
_______________________________________________
NA-User mailing list
NA-User@contesting.com
http://lists.contesting.com/mailman/listinfo/na-user
NA on the web: http://www.datomonline.com/
|