RFI
[Top] [All Lists]

Re: [RFI] My RFI - weekly report.

To: "Ray, W4BYG" <w4byg@att.net>
Subject: Re: [RFI] My RFI - weekly report.
From: Tom Haavisto <kamham69@gmail.com>
Date: Tue, 27 May 2014 19:18:01 -0400
List-post: <rfi@contesting.com">mailto:rfi@contesting.com>
For all the effort of "making it work" on an older radio, would it not be
easier to beg\buy\borrow something a bit newer while you track down the
noise source(s)?

I do understand the fascination with older gear, but there are limits to
what we can expect of it, and it becomes easier to use newer gear...

Tom - VE3CX



On Tue, May 27, 2014 at 6:04 PM, Ray, W4BYG <w4byg@att.net> wrote:

> Just wondering: if there have been any attempts to design or fabricate an
> outboard hardware adapter for older model radios to enable the use of S
> Meter Lite?
>
> I may be wrong, but it seems like some receiver's AGC voltage could be
> sampled in such a way as to interface with the S Meter Lite software.
>
> Ray, W4BYG
>
>
>
> -----Original Message-----
> From: RFI [mailto:rfi-bounces@contesting.com] On Behalf Of David Cole
> Sent: Monday, May 26, 2014 10:04 PM
> To: rfi@contesting.com
> Subject: Re: [RFI] My RFI - weekly report.
>
> Try S-Mater Lite...  See my review of it at:
> http://nk7z.net/review-of-s-meter-lite/
>
> Then download it at:
> http://www.seed-solutions.com/gregordy/Software/SMeterLite.htm
>
> Very handy program!
> --
> Thanks and 73's,
> For equipment, and software setups and reviews see:
> www.nk7z.net
> for MixW support see;
> http://groups.yahoo.com/neo/groups/mixw/info
> for Dopplergram information see:
> http://groups.yahoo.com/neo/groups/dopplergram/info
> for MM-SSTV see:
> http://groups.yahoo.com/neo/groups/MM-SSTV/info
>
>
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi
>
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi

<Prev in Thread] Current Thread [Next in Thread>