Hi,
I grounded the computer case to the computer ground on the motherboard,
then the case to an actual ground buss, and the ground buss is connected
to an actual ground.
Following that I added a few mix31 ferrite's to the DVI cable for the
monitor, one at the monitor end, and one at the computer end, and one in
the middle...
All of my computer/monitor RFI ended with those steps.
73s and thanks,
Dave
NK7Z
http://www.nk7z.net
On 05/29/2017 09:14 AM, Kenneth G. Gordon wrote:
Hmmm...well, yesterday, I found that a source of RFI on (at least) 40
meters is the desktop
computer sitting on my operating bench. RFI changes with changes in
the "scene" on the
screen.
Turning off the 'pooter resulted in noise level dropping to S-1
(transceiver in narrow CW) on
selected frequencies.
I'm not sure at this point how to fix this, but I'll be working on it.
What brought it to my attention was a weak but steady carrier on 7053,
which would
disappear when I changed to a different piece of software on the 'pooter.
Sigh.... :-(
If it isn't one thing, its another.
Ken W7EKB
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
RFI mailing list
RFI@xxxxxxxxxxxxxx
http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@xxxxxxxxxxxxxx
http://lists.contesting.com/mailman/listinfo/rfi