Trying to get N1MM and MMTTY set up for the very first time with my
ProII. Been listening to the W1AW RTTY bulletin this evening.
Everything prints fine on the ProII scope using the built-in RTTY
decoder, but only garbage prints in MMTTY. Not sure where to start,
also using a microKEYER. Settings in MMTTY are 'default', and the
signal levels and tuning appear to be spot on.
Any suggestions on things to check out? Thanks in advance!
73,
--
Tad Danley, K3TD
EM10dq
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|