>>>AA6YQ comments below
-----Original Message-----
From: rtty-bounces@contesting.com [mailto:rtty-bounces@contesting.com]On
Behalf Of Ed Magnuson
Sent: Monday, January 26, 2009 7:59 AM
To: Dave AA6YQ; BIll Duffy; RTTY Reflector
Subject: Re: [RTTY] EU1SA, AA6YQ profiles in MMTTY
My OmniV at one of my two QTHs does not provide for rig control via computer
so I am not using WinWarbler. But can I just copy those new profiles from
the parauser.ini file and over-ride the one in my standalone MMTTY program?
>>>Yes. You can define up to 8 Profiles in a UserPara.ini file, so you
probably don't need to over-ride anything. I'd make a copy of your original
UserPara.ini file encase you make a mistake while editing. You wouldn't want
to be "down" just when 7O1RY is spotted as "begging" on 14080.
>>>WinWarbler does not require rig control, by the way. You can configure it
to switch your OmniV between RX and TX using a serial port modem control
signal and a simple level converter.
73,
Dave, AA6YQ
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|