On Thu, Jun 17, 2010 at 11:33, Tom Martin <tmartin@chartermi.net> wrote:
> I have two questions for the reflector:
>
> 1. To operate 75 baud do you just check it in MMTY.? No other changes in
> the program setup?
That's it. It's in the "Decode" tab, oddly.
I use FSK and I use the EXTFSK add-on to MMTTY to handle keying the
rig and since that module ONLY does 45.45 bauds, I had to rearrange
things to allow me to avoid that issue but that wasn't strictly an
MMTTY issue. If I'd never used EXTFSK in the first place, all I would
have had to do was change MMTTY to 75 bauds.
--
Peter Laws | N5UWY | plaws plaws net | Travel by Train!
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|