The uH Router is working OK with MacloggerDX and Mac OS X 10.7.5
I tryed it today. I will try it with cocoaModem later.
73
Torben OZ9GA
Den 19/11/2012 kl. 20.58 skrev Kok Chen:
>
> On Nov 19, 2012, at 11:23 AM, Al Kozakiewicz wrote:
>
>> Why, then, is there a Mackintosh (OS/X) section in the uHam drivers download
>> page?
>
> Isn't that just the FTDI (serial port) driver?
>
> MicroHAM uses a packetized "Keyer Protocol" to encapsulate everything (rig
> control, FSK keying, CW keying, etc) into a single 230 kb/sec serial stream.
> You can find a short description of what is needed to communicate with the
> MicroHAM interface here:
>
> http://www.w7ay.net/site/Applications/Router/Contents/keyerprotocol.html
>
> To send just a single FSK character, you need to embedded the Baudot
> character into a correctly formatted packet of 16 bytes (20 bytes if you want
> to key a second radio). Likewise, each byte of rig CAT control takes 4
> bytes, etc.
>
> Router (on Windows) and uH Router (my program for the Mac) does this
> packetizing for you. (I believe RUMped/RUMlog also has means of talking
> directly to the "Keyer Protocol" interface.)
>
> uH Router is only used by MacLoggerDX and cocoaModem on Mac OS X. Further,
> since I use Mac OS X 10.6 on all of my development machines, uH Router may or
> may not work on Mac OS X 10.7 and 10.8.
>
> 73
> Chen, W7AY
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
Torben Kahr
oz9ga@kahrius.dk
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|