The MMTTY engine takes care of everything. 75 baud RTTY is still 170Hz shift
between mark and space. The only difference is the baud rate set for the UART.
Al
AB2ZY
________________________________________
From: RTTY [rtty-bounces@contesting.com] On Behalf Of David VE3VID
[ve3vid@hotmail.com]
Sent: Wednesday, April 24, 2013 2:14 PM
To: N1MM Digital; RTTY contest group
Subject: [RTTY] 75 baud question
I would like to try 75 baud in the BARTG event but am unsure on how to set this
up. Currently using MMTTY with N1MM, set up for FSK done by a Kenwood TS-450.
What settings need to be able to do 75 baud?
The TS450 has FSK shift settings of 200 450 and 850hz. Do I set one of these
for 75 baud?
On MMTTY setup under Decode tab, BaudRate setting - Is this the only adjustment
for MMTTY?
73David
VE3VID
Located in rural Canada
Solar power. Wood heat.
Mosley tribander @ 10m
Lots of space for dipoles,
bears and wolves......73
http://www.ve3vid.webs.com/
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|