Thanks AlThat sounds easy enough, just didn't want to miss a step.cheersDavid
http://www.ve3vid.webs.com/
> From: akozak@hourglass.com
> To: ve3vid@hotmail.com; n1mmlogger-digital@yahoogroups.com;
> rtty@contesting.com
> Date: Wed, 24 Apr 2013 14:17:36 -0400
> Subject: Re: [RTTY] 75 baud question
>
> The MMTTY engine takes care of everything. 75 baud RTTY is still 170Hz shift
> between mark and space. The only difference is the baud rate set for the
> UART.
>
> Al
> AB2ZY
>
> ________________________________________
> From: RTTY [rtty-bounces@contesting.com] On Behalf Of David VE3VID
> [ve3vid@hotmail.com]
> Sent: Wednesday, April 24, 2013 2:14 PM
> To: N1MM Digital; RTTY contest group
> Subject: [RTTY] 75 baud question
>
> I would like to try 75 baud in the BARTG event but am unsure on how to set
> this up. Currently using MMTTY with N1MM, set up for FSK done by a Kenwood
> TS-450.
> What settings need to be able to do 75 baud?
> The TS450 has FSK shift settings of 200 450 and 850hz. Do I set one of these
> for 75 baud?
> On MMTTY setup under Decode tab, BaudRate setting - Is this the only
> adjustment for MMTTY?
> 73David
>
>
> VE3VID
> Located in rural Canada
> Solar power. Wood heat.
> Mosley tribander @ 10m
> Lots of space for dipoles,
> bears and wolves......73
>
> http://www.ve3vid.webs.com/
>
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|