RTTY
[Top] [All Lists]

Re: [RTTY] using fldigi with TS2000

To: rtty@contesting.com
Subject: Re: [RTTY] using fldigi with TS2000
From: "Joe Subich, W4TV" <lists@subich.com>
Date: Wed, 29 Jan 2014 20:41:13 -0500
List-post: <rtty@contesting.com">mailto:rtty@contesting.com>

Anyway, I was using pin 9 with FSK and N1MM and that was working. For
AFSK, it is my understanding that pin 9 will mute the microphone
input on pin 11.

That is incorrect.  Pin 9 PTT mutes the *microphone input* - the mic
jack on the front of the transceiver (Mic jack).  Pin 11 is PKD -
you connect AFSK (or TNC, MCP, etc.) audio there - Pin 9 (PKS) selects
PKD which disables compression and clipping.  *READ THE MANUAL* - see
the description of ACC2 on Page 95.

If Pin 11/Pin 9 work in N1MM Logger and do not work in fldigi, you have
a configuration issue with fldigi and should seek help from those who
know fldigi.  Make sure fldigi is actually triggering the PTT line on
pin 9 and not trying to switch the rig using CAT commands since they
likely to be *wrong* (equivalent to pin 13).

73,

   ... Joe, W4TV


On 1/29/2014 8:15 PM, Lee wrote:
Actually, this wouldn't be specific to fldigi since it's a general issue for
AFSK.

Anyway, I was using pin 9 with FSK and N1MM and that was working. For AFSK, it
is my understanding that pin 9 will mute the microphone input on pin 11.
According to the TS2000 manual, I need to key the radio with pin 13 so that
pin 11 isn't muted on key down.

I've tried both pin 9 and pin 13 with the same result (no AFSK transmitted).

Joe Subich, W4TV <lists@subich.com> wrote ..

This should really be asked on the fldigi support forum ...

TS-2000 requires PTT on pin 9 (PKS) when applying audio on pin 11 (PKD).
See the description of those pins on page 94 of the TS-2000 Instruction
Manual.

73,

     ... Joe, W4TV


On 1/28/2014 9:57 PM, Lee wrote:
I believe that I have my PC-to-radio interface cable set up right but I
can't
seem to transmit any audio. The radio is keyed but no transmit audio. I
have
audio to ACC2-11 and my keying is on ACC2-13. I don't see any radio menu
options that would cause an issue. Also, with the microphone attached, I
can
transmit voice when the PC keys the radio so the microphone audio from
ACC2
shouldn't be muted. Receive is working properly though. What am I missing?
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>