RTTY
[Top] [All Lists]

Re: [RTTY] RTTY DX'ing tutorial (was: VK0EK RTTY Update)

To: <rtty@contesting.com>
Subject: Re: [RTTY] RTTY DX'ing tutorial (was: VK0EK RTTY Update)
From: "Ed Muns" <ed@w0yk.com>
Reply-to: ed@w0yk.com
Date: Sun, 10 Apr 2016 18:22:10 -0700
List-post: <rtty@contesting.com">mailto:rtty@contesting.com>
Radios with a second receiver (not just another VFO on a single receiver)
can decode two different frequencies simultaneously.  The DX station is in
one decoder window and the pileup is in another.  With a bandscope, you can
usually ID the station being worked, move your second receiver there and
decode to verify.  If you're in Split mode, then transmitting will occur on
the Split frequency, i.e., the second receiver, or VFO-B.  I don't know how
we ever worked a split pileup spread over 15 Khz without these aids.   ;>)

Ed W0YK
______________________________________________________________________

Art K5FNQ wrote:

On a DXpedition RTTY split mode, unlike CW where it is possible to 
listen for and read the frequency of the calling station being worked, 
RTTY on split does not provide that option to print the station on VFOB, 
at least not that I can see.  No way to print from VFOB to try and find 
the station being worked.  It becomes a crapshoot (using NAP3 and LP PAN 
to try and see the signal of the RTTY station being worked is impossible 
with the "call all of the time" crowd.)  Is there any way around this?

Hopefully I have overlooked some command or system to read both VFOA and 
VFOB on my FT5000 on any RTTY program???

_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>