My Omni V tuning knob has a "chatter" or "rattle" when I turn it very fast.
Its not a big problem mind you, just a minor annoyance on an otherwise great
feeling control panel. I opened it up and looked at the Clarostat shaft
encoder that the knob is tied to and found that the chatter is actually in
the shaft encoder itself. I can feel it when I just turn the knob on the
Clarostat device.
Is this normal? Or is the bearing in mine wearing out? Has anybody had any
success improving this condition?
Thanks!
- Tom
_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
Tom Scott - Wyle Electronics - KD7DMH
10300 SW Nimbus Ave #PB, Portland, OR 97223
503-603-1931 - TEL 503-684-6620 - FAX
503-504-1583 - Cell 503-604-8651 - Pager
_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|