Hi Bill:
I don't know what to tell you. I run a amp set for 450 watts CW output with
my Jupiter set at 42% and when I go to TUNE I sure have 450 watts out of the
amp.
73's
Jack, W7EJJ
----- Original Message -----
From: <Bill_Ames@hyperion.com>
To: "Jack Malone" <malonej@c2i2.com>
Cc: "Ten-Tec" <tentec@contesting.com>
Sent: Friday, April 06, 2001 7:37 AM
Subject: Re: [TenTec] Jupiter question
>
>
> Which is not logical as even my Scout reduced power in the Tune position!
>
>
>
>
>
>
> "Jack Malone" <malonej@c2i2.com> on 04/05/2001 04:48:34 PM
>
> To: Bill Ames/na/Hyperion@Hyperion
> cc: "Ten-Tec" <tentec@contesting.com>
> Subject: Re: [TenTec] Jupiter question
>
>
> Don't quite understand your question.
> However you set your output power with the menu and whatever that is set
at
> is what your tune will output.
> I suspect you meant can the tune be set at a different level than the
> normal
> output, and the answer is NO, output and tune will always be the same as
> the
> setting you make on menu.
> --
> Jack, W7EJJ
>
> ----- Original Message -----
> From: <Bill_Ames@hyperion.com>
> To: <tentec@contesting.com>
> Sent: Thursday, April 05, 2001 5:38 AM
> Subject: [TenTec] Jupiter question
>
>
> >
> > Can the tune level output be set by software so when the Tune button is
> > engaged the output will be at a level I can predetermine?
> >
> > Bill Ames
> > KB1LG
> >
> >
> > --
> > FAQ on WWW: http://www.contesting.com/FAQ/tentec
> > Submissions: tentec@contesting.com
> > Administrative requests: tentec-REQUEST@contesting.com
> > Problems: owner-tentec@contesting.com
> >
> >
>
>
>
>
>
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/tentec
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
>
>
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|