There was an Omni A and Omni D of the 'B' series too.
The 'C' series was the only one that did not offer an analog readout
version and was really only referred to as an Omni C.
I don't remember the difference between the first Omni and the Series 'B'
Omni. I was thinking one thing had something to do with the way the xtal
filters were selected.
Dan
WD4LUR
<n4lq@iglou.com>
Sent by: To: "Ron McConnell"
<rcmcc@earthlink.net>, "Ten-Tec list"
tentec-admin@cont <tentec@contesting.com>,
"W2IOL" <w2iol@arrl.net>
esting.com cc:
Subject: Re: [TenTec] OMNI D
546 Series A mods?
08/20/2002 12:30
PM
Model A had an "analog" display...Non Digital.
Model D had a "digital" display
Model D had 2 series, B and C.
Going from model A to model D series B would require installation of a
frequency counter. Not really practical.
Steve N4LQ
-----Original Message-----
From: "Ron McConnell" <rcmcc@earthlink.net>
To: "Ten-Tec list" <tentec@contesting.com>
To: <tentec@contesting.com>
Date: Tue, 20 Aug 2002 11:57:49 -0400
Subject: [TenTec] OMNI D 546 Series A mods?
>
> The Ten-Tec FAQ page address I have
> http://www.contesting.com/TenTecFAQ.html
> comes up "Invalid Page Location."
>
> I find myself the surprised owner of
> an OMNI D 546 Series A rig, courtesy
> of a ham who gave it a non-ham buddy
> of mine who then gave it to me.
> I got the manual and a power cord from Ten-Tec.
>
> Since there was at least a Series B,
> I assume that there are mods to Series A.
> Any suggestions on what are the
> "low hanging fruit" mods and where
> to find info on them?
>
> Thanks.
>
> Cheers,
>
> Ron McConnell
> w2iol
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
--
NOTICE: This e-mail message and all attachments transmitted with it may
contain legally privileged and confidential information intended solely
for the use of the addressee. If the reader of this message is not the
intended recipient, you are hereby notified that any reading,
dissemination, distribution, copying, or other use of this message or
its attachments, hyperlinks, or any other files of any kind is strictly
prohibited. If you have received this message in error, please notify
the sender immediately by telephone (865-218-2000) or by a reply to this
electronic mail message and delete this message and all copies and
backups thereof.
|