TenTec
[Top] [All Lists]

[TenTec] PTO grease

To: <tentec@contesting.com>
Subject: [TenTec] PTO grease
From: jlockj@earthlink.net (John)
Date: Tue, 3 Sep 2002 19:21:48 -0500
The last rebuild kit I bought from Ten Tec was in 2001 and it contained
green (?axle?) grease.

I haven't heard of people using Lubriplate in PTO's, however, I do know of
hams NOT happy with it's long-term performance in rotators.  (really dries
out - in a shorter time than factory grease)

John  W0DC

----- Original Message -----
From: "Steve Ellington" <n4lq@iglou.com>
To: "Mike Hyder -N4NT-" <N4NT@charter.net>; "White, Joseph H."
<jhw@rti.org>; <tentec@contesting.com>
Sent: Wednesday, September 04, 2002 11:56 AM
Subject: Re: [TenTec] PTO grease


> Red axel grease is used on farm tractors and wheel bearings. This is no
> doubt what they use. If we could find some that doesn't dry out, it would
> solve the whole problem.
> Steve Ellington N4LQ.
> ----- Original Message -----
> From: "Mike Hyder -N4NT-" <N4NT@charter.net>
> To: "White, Joseph H." <jhw@rti.org>; <tentec@contesting.com>
> Sent: Tuesday, September 03, 2002 10:52 AM
> Subject: Re: [TenTec] PTO grease
>
>
> > About 3 years ago I rebuilt several PTO's using Phil Woods bicycle
grease.
> > It was highly touted as being a great grease.
> >
> > The one of those PTO's I was using lately (in a Triton 544) has gotten
> > squirrely to tune -- acts like the grease has gone or is going bad.  SO,
I
> > don't recommend that grease for this application.
> >
> > Once I talked with Garland down at Ten-Tec about grease and he told me
> they
> > just got it down at the co-op.  I don't know what kind they got at the
> > co-op, but it sure does last better than my fancy stuff did.
> >
> > 73, Mike
> >
> > ----- Original Message -----
> > From: "White, Joseph H." <jhw@rti.org>
> > To: <tentec@contesting.com>
> > Sent: Tuesday, September 03, 2002 10:40 AM
> > Subject: [TenTec] PTO grease
> >
> >
> > | I'm fixing up my Century 21 which has been in storage in hopes of
> selling
> > | it.  The grease in the PTO has stiffened from lack of use, so I'd like
> to
> > | relubricate it.  I don't think I need to install a rebuild kit,
because
> > this
> > | rig has seen very little use.  What kind of grease should I use?
> > |
> > |     joe white
> > |     WA4GIR
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec


<Prev in Thread] Current Thread [Next in Thread>