TenTec
[Top] [All Lists]

[TenTec] Paragon Improvements

To: <tentec@contesting.com>
Subject: [TenTec] Paragon Improvements
From: mark.rauchfuss@worldnet.att.net (Mark Rauchfuss)
Date: Sun Feb 2 20:14:08 2003
Hi,

Does anyone know the serial numbers for the Paragon transceivers. I
would like to know what the serial number for the first production and
very last Paragons were. By knowing this information, I can know what
constitutes an early one versus a later one.

Thanks for the help,


Mark,
K8GKZ

-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com] On Behalf Of Stan Korzep
Sent: Sunday, February 02, 2003 11:41 AM
To: tentec@contesting.com
Subject: [TenTec] Paragon Improvements


Hi All

I acquired a very low serial number Paragon some weeks ago.  It came
with a
built in 130 Hz frequency offset between receive and transmit mode which
only occurred on USB.  Factory service tried hard to give me some hints,
but was only able to suggest a firmware upgrade which had no effect.  I
did
find the problem ....... the hard way.  Apparently this problem was
built
into many early Paragons, but was cured in later ones.

Last month K8GVK asked if there were cataloged modifications to the
Paragon, and got a response listing a site with non-Ten-tec mods.  Is
there
any place where the factory modifications which were implemented during
the
manufacturing life of the Paragon are cataloged?  I asked this question
of
the Ten-tec service department:  they replied that no such list existed.

My Paragon has some minor remaining problems which I would like to clean
up
this year.  Can anyone help please?

Stan  W8NNX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>