Thanks Mike!
Now all I need to do is get a manual.
Best 73s,
Mark
WD7WEO
----- Original Message -----
From: "Mike Hyder --N4NT--" <N4NT_Mike.Hyder@charter.net>
To: <tentec@contesting.com>
Sent: Sunday, August 10, 2003 8:05 AM
Subject: Re: [TenTec] Omni-C & Spare Parts
> it didn't come out of the rig
>
> 73, Mike N4NT
>
> ----- Original Message -----
> From: "Mark Rauchfuss" <mark.rauchfuss@worldnet.att.net>
> To: <tentec@contesting.com>
> Sent: Sunday, August 10, 2003 7:18 AM
> Subject: [TenTec] Omni-C & Spare Parts
>
>
> I recently came into a good deal for an Omni-C, matching VFO and power
> supply and so picked same up.
>
> When the boxes were unpacked, I noticed a 2N2222 transistor (TO-5) laying
> on the floor. It has not been soldered into a board (leads not tinned) but
> perhaps it was mounted on a socket (?). It obviously came out of one of
the
> boxes.
>
> The question I now have is where did it come from and what does it do? At
> the present time, I don't have a manual for this station and would like to
> know what this transistor does before I turn it on.
>
> Does anyone have any ideas?
>
> Comments very much appreciated.
>
> 73s,
>
> Mark,
> WD7WEO
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|