Get it from Ten-Tec. They are reasonable and they do a good job with
fold-out sheets, too.
Mike N4NT
----- Original Message -----
From: "Mark Rauchfuss" <mark.rauchfuss@worldnet.att.net>
To: <tentec@contesting.com>
Sent: Sunday, August 10, 2003 8:16 AM
Subject: Re: [TenTec] Omni-C & Spare Parts
> Thanks Mike!
>
> Now all I need to do is get a manual.
>
> Best 73s,
>
>
> Mark
> WD7WEO
>
> ----- Original Message -----
> From: "Mike Hyder --N4NT--" <N4NT_Mike.Hyder@charter.net>
> To: <tentec@contesting.com>
> Sent: Sunday, August 10, 2003 8:05 AM
> Subject: Re: [TenTec] Omni-C & Spare Parts
>
>
> > it didn't come out of the rig
> >
> > 73, Mike N4NT
> >
> > ----- Original Message -----
> > From: "Mark Rauchfuss" <mark.rauchfuss@worldnet.att.net>
> > To: <tentec@contesting.com>
> > Sent: Sunday, August 10, 2003 7:18 AM
> > Subject: [TenTec] Omni-C & Spare Parts
> >
> >
> > I recently came into a good deal for an Omni-C, matching VFO and power
> > supply and so picked same up.
> >
> > When the boxes were unpacked, I noticed a 2N2222 transistor (TO-5)
laying
> > on the floor. It has not been soldered into a board (leads not tinned)
but
> > perhaps it was mounted on a socket (?). It obviously came out of one of
> the
> > boxes.
> >
> > The question I now have is where did it come from and what does it do?
At
> > the present time, I don't have a manual for this station and would like
to
> > know what this transistor does before I turn it on.
> >
> > Does anyone have any ideas?
> >
> > Comments very much appreciated.
> >
> > 73s,
> >
> > Mark,
> > WD7WEO
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
|