| To: | <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] 450 Ohm feedline tuners |
| From: | "Stuart Rohre" <rohre@arlut.utexas.edu> |
| Reply-to: | tentec@contesting.com |
| Date: | Mon, 19 Apr 2004 13:42:12 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
A source for mechanical parts to link roller inductors, or two caps is "Small Parts. Inc." in FL. with a little drawing one can fit two roller inductors into a compact box, at right angles to each other, and use a do degree bevel gear coupling to drive them from one shaft knob. Other schemes can be thought up as well. -Stuart K5KVH _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| Previous by Date: | [TenTec] Pegasus DSP Project, Mark Erbaugh |
|---|---|
| Next by Date: | Re: [TenTec] 450 Ohm feedline, Stuart Rohre |
| Previous by Thread: | [TenTec] MFJ-974H Balanced Tuner, NJ0IP |
| Next by Thread: | Re: [TenTec] 450 Ohm feedline tuners, Vern Kunes |
| Indexes: | [Date] [Thread] [Top] [All Lists] |