Martin,
According to what I have read here on contesting.com it will be the cable in
the end. Someone had this problem a few weeks back and commented on it.
Hopefully they will answer your question soon.
Van N5HTY
-------Original Message-------
From: tentec@contesting.com
Date: 08/24/04 20:35:57
To: tentec@contesting.com
Subject: [TenTec] Steppir vs Orion
Just got my SteppIR up yesterday. All is well, except...
Hooked the Orion serial port to the Steppir data in using
Steppir-supplied "K2" cable. Set everything up according to manual, I
think. No communication, despite power cycling, master reset, etc.
This is with firmware 1.371.
There was a lot of discussion a few months back about Orion/steppir.
One may be forgiven for naively thinking it should work out of the box
for current production.
Anyone know the scoop? TIA
73, Martin, AA6E
pics at www.aa6e.net/aa6e
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|