Okay guys,
Thanks for information, I knew this "battery failure" was not a "real" error
message... but I'd like to be sure !
Obviously, it is necessary to aknowledge that the first time I saw this
message, I was a little bit skeptical about the fact that I have 2 replace a
new battery by a new one ! ;-)
Anyway... the problem is for the dealer now, he has to figure out what could
be the cause of all this mess.
Good evening,
Eric.
-----Message d'origine-----
De : tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]De la part de Tommy
Envoyé : dimanche 26 septembre 2004 20:43
À : tentec@contesting.com
Objet : Re: [TenTec] New firmware for the Orion...
Gene,
'Battery Failure' also appears when you perform the RAM Clear reset
function. In this case, it does not mean you have a battery failure.
Tom - W4BQF
-- Original Message -----
From: "Gene Henderson" <ghenderson@insightbb.com>
To: <eric.sensi@skynet.be>; <tentec@contesting.com>
Sent: Sunday, September 26, 2004 12:43 PM
Subject: Re: [TenTec] New firmware for the Orion...
> If you are seeing battery failure call Ten-Tec and they will send you a
new
> battery. I had a bad battery in mine and it was only one month old. Gene
> BUHL
> ----- Original Message -----
> From: "Eric SENSI" <eric.sensi@skynet.be>
> To: <tentec@contesting.com>
> Sent: Sunday, September 26, 2004 2:09 AM
> Subject: RE: [TenTec] New firmware for the Orion...
>
>
> > My dealer is calling this the "RAM clear procedure"...
> >
> > I did this at least 10 times but on the top of the screen it was
mentioned
> > :
> >
> > "BATTERY FAILURE" (not "battery test")
> >
> > Is this supposed to be the right message or not ?
> >
> > Eric, ON6CV.
> >
> > -----Message d'origine-----
> > De : tentec-bounces@contesting.com
> > [mailto:tentec-bounces@contesting.com]De la part de Tommy
> > Envoyé : dimanche 26 septembre 2004 2:49
> > À : tentec@contesting.com
> > Objet : Re: [TenTec] New firmware for the Orion...
> >
> > Duane,
> >
> > If you haven't already, maybe try the memory reset. I certainly don't
know
> > for sure, but that sounds more like a memory problem than a firmware
> > problem
> > (my guess only). (Hold down VFO B Lock button and power cycle. It comes
up
> > with a 'Battery Test' note, but supposed to reset the memory)
> >
> > Good luck,
> >
> > Tom - W4BQF
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|