Tim...
What power supply are you using?
Phil K4DPK
VFO Stabilizers, PEP Adapters for Wattmeters ... see
http://home.comcast.net/~k4dpk
----- Original Message -----
From: "Tim & Darlene Isom" <nannypoo@mnmars.org>
To: <tentec@contesting.com>
Sent: Sunday, September 26, 2004 11:29 PM
Subject: [TenTec] Paragon behavior
> I am a sysop for a MARS PACTOR switch. We are using Paragons for
> the switch operation and I am wondering if anyone has seen the
> following behavior and if so what is the problem and perhaps the cure.
>
> On Saturday, 25 September, I had to check our PACTOR switch
> because no one was able to log into the switch to get traffic. I
> initially found the Paragon working but the audio was just a loud
> buzz and when the tuning dial was turned the display remained on
> the same frequency even though I was moving the tuner. I did a
> hard reset of the rig and things seemed to be cured.
>
> Today, 26 September, I had to again check the switch due to the
> same problem. I turned the rig off and on (without a reset) and
> things were fine, I then had another operator connect to the
> switch - as traffic was being downloaded by the remote operator
> the switch was functioning but then stopped - the TNC (a PK232MBX)
> had the send light lock on, however the rig was no longer
> transmitting, my loud noise was back and the display was blank. I
> do not believe the problem is with the TNC - I believe the issue
> is related to the radio.
>
> Any help would be appreciated.
>
> Tim Isom WD9HDQ/NNN0XEE
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|