It's probably the switch on the back panel which switches between the normal
antenna and the RX antenna. Just switch it back and forth 10 times and then
try it again.
73
Rick
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Jim Miller WB5OXQ
Sent: Thursday, November 25, 2004 2:37 PM
To: tentec@contesting.com
Subject: [TenTec] Omni 6+ rx dead
My old faithful and beloved omni 6+ had no receive when I turned it on last
night. It will transmit fine but the receiver acts like there is no antenna
connected to it on all bands. There are the usual birdies here and there
and it will receive the signal from another hf rig who's antenna is about
50' away. The 100 watt signal from the other rig gives only about a S5 on
the omni's S meter. I cnecked the antenna connections and the rca cables to
and from the qsk connection on the Centurion and all seems good. I replaced
the amp cables with a jumper with no results.
Unless someone has a suggestion I guess it is off to TenTec Service.
Jim in Waco, WB5OXQ.
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.289 / Virus Database: 265.4.2 - Release Date: 11/24/2004
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|