To: | tentec@contesting.com |
---|---|
Subject: | Re: [TenTec] INRAD Omni VI roofing filter kit - success |
From: | Clark Savage Turner <csturner@kcbx.net> |
Reply-to: | tentec@contesting.com |
Date: | Sun, 16 Jan 2005 13:17:25 -0800 |
List-post: | <mailto:tentec@contesting.com> |
On Jan 16, 2005, at 12:35 PM, Rick and Karen Bunn wrote: Would this kit work in the Corsair II or the Paragon II? The Corsair should have no need for such a thing. You don't have a wide roofing filter, you already have more roofing filter than the OMNI VI does :-) . Does the Paragon upcovert or use a VHF first IF? If so, this kit won't apply. It only applies if your first IF is 9 MHz and has a wide filter there at the head of the IF chain. I've never had a Paragon, don't know how it works, check your schematic. Clark WA3JPG Clark Savage Turner, J.D., Ph.D. Associate Professor of Computer Science Cal Poly State University San Luis Obispo, CA. 93407 _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
Previous by Date: | RE: [TenTec] Orion/2000A Arc Fault (was RE:Firmware upgradeandCW/ACOM2000A issue again), Barry N1EU |
---|---|
Next by Date: | [TenTec] FS: Corsair and PS, dave |
Previous by Thread: | RE: [TenTec] INRAD Omni VI roofing filter kit - success, Rick and Karen Bunn |
Next by Thread: | [TenTec] INRAD Omni VI roofing filter kit - success, Rick Williams |
Indexes: | [Date] [Thread] [Top] [All Lists] |