TenTec
[Top] [All Lists]

Re: [TenTec] Delta II and Signalink SL-1+

To: <tentec@contesting.com>
Subject: Re: [TenTec] Delta II and Signalink SL-1+
From: "Mark Erbaugh" <mark@microenh.com>
Reply-to: tentec@contesting.com
Date: Sun, 16 Jan 2005 18:04:20 -0500
List-post: <mailto:tentec@contesting.com>
Jerry,

Contact Tigertronics (makers of the SL1). They can give you recommendations
for padding resistors to reduced the drive to the radio.

73,
Mark

----- Original Message ----- 
From: "Jerry Schantz" <jschantz@franklinisp.net>
To: <tentec@contesting.com>
Sent: Sunday, January 16, 2005 1:19 PM
Subject: [TenTec] Delta II and Signalink SL-1+


> Hello Group,
> Trying to get my Delta II set up with a SL-1+ , using the accessory
> jack. Can not seem to get it to work correctly without over driving the
> radio.
>  Lowering the level out of the sound card doesn't do much except
> "killing " the keying on the SL-1. It's keyed with a tone level from the
> sound card. Have also tried a divider between the interface and radio,
> thinking a 100 :1 would work but no luck. Always seems to go into ALC
> unless the mic gain is almost reduced to 0. Think I just need more
> reduction of level going into the radio but am sort of frustrated at
> this point. Am just not finding the right combo.
> The goal is to be able to use the mic, OR the sound card interface with
> out changing mic gain , or other settings.
> Has anyone been here and found the magic combination ??
> Tnx
>
> Jerry  W9JJS
>
>
>
> -- 
> No virus found in this outgoing message.
> Checked by AVG Anti-Virus.
> Version: 7.0.300 / Virus Database: 265.6.11 - Release Date: 1/12/05
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>