TenTec
[Top] [All Lists]

Re: [TenTec] OUT OF HAM BAND MODIFICATION

To: tentec@contesting.com
Subject: Re: [TenTec] OUT OF HAM BAND MODIFICATION
From: joel hallas <jrhallas@optonline.net>
Reply-to: tentec@contesting.com
Date: Mon, 17 Jan 2005 12:14:43 -0500
List-post: <mailto:tentec@contesting.com>
Folks,

Sorry to say the chart formatting was lost in transition. Here it is, hopefully readable.

BTW, I put the appropriate offset channels in memory to make sure I end up in the right place, per the ARRL Web page:

This chart from the NTIA suggests appropriate tuning frequencies for each center-channel frequency:

Channel Center Amateur Tuning Frequency (USB only)

5332 kHz 5330.5 kHz

5348 kHz 5346.5 kHz

5368 kHz 5366.5 kHz

5373 kHz 5371.5 kHz

5405 kHz (common US/UK) 5403.5 kHz

In case anyone hasn't seen the chart.

73, Joel, W1ZR


Jim Bull wrote:


Bob,
On my two Paragon's, the MARS/CAP/60M mod is accomplished by cutting/unsoldering the jumper wire on the logic board (Labeled "HAM")
and resetting the processor. The jumper is located directly below the
9 volt memory battery.


NOW, if someone can tell me what/where the mod is on the Paragon II,
I would appreciate it VERY much.

Jim/Ke3nK
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,

Robert Lutz wrote:

Does anyone have the modification to make the Paragon transmit out of
band

tnx 73 Bob

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>