TenTec
[Top] [All Lists]

Re: [TenTec] RE: Orion AUX out audio question

To: <tentec@contesting.com>
Subject: Re: [TenTec] RE: Orion AUX out audio question
From: "Tommy" <aldermant@alltel.net>
Reply-to: tentec@contesting.com
Date: Sun, 23 Jan 2005 11:41:49 -0500
List-post: <mailto:tentec@contesting.com>
Actually Ten Tec request all bug reports should go direct to ditsnbits via their direct email address. About the only Ten Tec folks who monitor this reflector are the sales guys. Can't really blame them for some of the comments here get pretty far off base!!

Tom - W4BQF

----- Original Message ----- From: "John Perkins" <john@jmp2.wanadoo.co.uk>
To: <tentec@contesting.com>
Sent: Sunday, January 23, 2005 11:21 AM
Subject: [TenTec] RE: Orion AUX out audio question



Can I also echo the wishes of Martin & Bob.

**********************************
**********************************

Line Level SHOULD BE FIXED (as per the label)
at 0dBm across 600 ohms = 0.775volts,
IRRESPECTIVE of the volume controls.

**********************************
**********************************

If TenTec see more people confirm this, then perhaps they will
add it to the firmware "to do" list.

John G3PPB


------------------------------


Message: 9
Date: Sun, 23 Jan 2005 06:09:50 -0800 (PST)
From: Martin AA6E <msembx-aa6e@yahoo.com>
Subject: Re: [TenTec] Orion AUX out audio question
To: tentec@contesting.com
Message-ID: <20050123140950.29072.qmail@web81403.mail.yahoo.com>
Content-Type: text/plain; charset=us-ascii

Tommy,

My rig does not behave that way. Left=Sub produces constant output
unless you zero out the Sub AF volume. (v 1.372) In that case the aux.
output is blanked out.


Thinking about this a little more, I think the TT logic is just wrong
for my use. I want the aux. output to be completely independent of
front panel level controls. That's what "line out" normally means.
This could be fixed in firmware -- and/or made a menu option.


73, Martin AA6E

--- Tommy <aldermant@alltel.net> wrote:

..however if you have
LEFT set for SUB, you can vary the audio level at pin 4 using the
SubRx AF control.




------------------------------

Message: 11
Date: Sun, 23 Jan 2005 09:38:42 -0500
From: "Robert Carroll" <rlcarroll@patmedia.net>
Subject: RE: [TenTec] Orion AUX out audio question
To: <msembx-aa6e@yahoo.com>, <tentec@contesting.com>
Message-ID: <20050123143849.1F12F4CC9D@mail.patmedia.net>
Content-Type: text/plain; charset="us-ascii"

Martin-

I would like to see line out as you described your wishes.

Bob W2WG

__________________

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>