Mike,
Thanks for the description. Sounds great.
I already found one about a year ago. I bought it and had it shipped to my
mom's house where it has been sitting in storage ever since. Next week I
will fly over for a visit and then plan to hand-carry the amp back to
Germany. I also have the HP-24, but didn't get the HP-14. I don't plan any
mobile operations with it.
I run openwire fed antennas here, so I have to tune a matchbox each time I
change bands. However I do get a perfect match on all bands. I really like
the simple tune up of the HA-14 because tuning both a matchbox and an amp
can be a pain.
I'll carry the amp in my hand baggage and the P.S. will go in the check-in
baggage. It sounds like the amp is about the size of two laptops stacked on
top of each other. I have several computer bags, so I'll check the
measurements and be to take a bag that it can fit in.
Thanks again for your help.
73
Rick
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Tim Soxman
Sent: Friday, March 04, 2005 11:29 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] OT: Heathkit HA14 measurements?
Heathkit HA-14 SSB Linear Amplifier
The amplifier is 12-13/16" wide x 3-3/16" high x 10" deep.
Band Coverage is 80, 40, 20, 15, and 10 meters.
Power input SSB: 1000 watts P.E.P.
Driving power up 100 watts for full output.
Output Impedance 50 ohms unbalanced, SWR not to exceed 2:1.
Input Impedance 52 ohms unbalanced; broad-band pretuned input (circuit
requires no tuning)
Meter Functions Relative power and 1:1 to 3:1 SWR.
Front Panel Controls Tune: 80, 40, 20, 15, and 10 meters.
Band 80, 40, 20, 15, and 10 meters.
Relative Power Sensitivity control.
Meter switch: FWD And SWR.
Power switch: OFF, ON.
Tube Complement Two 572-B (or two T160-L) in parallel.
Power Requirements 2000 volts DC at 500 ma and -120 volts DC at 60 ma,
an 12.6 Volts Dc at 4 amperes.
Net Weight 7 Lbs.
Now lets get to how well it operates, In the real world, it will run 500
watts output useing a Bird model 43 watt meter. I have only checked it on
80, 40, and 20 meters, but i am sure it will be a little less on 15, and
10 meters. There is no standby position so you can not use your exciter
barefoot unless you turn it off. Also i would use a small 12 volt muffin
fan above the 572-b tubes to keep them cool. (There is no internal fan).
As you can see with no fan it is very quite. I am useing brand new
Taylor matched 572-b tubes.
The original tubes Heathkit used in this model was Cetron 572-B/T160L.
To operate the HA-14 mobile amplifier you set the band switch to the
disired band, do not turn it on. Load the exciter in a normal manner at the
desired frequency. The FWD and SWR functions of the Amplifier meter can
be used in loading the exciter. Reduce the drive level of the exciter to a
minimum. Turn on the HA-14 Amplifier and apply a small amount of RF from
the exciter. Peak the tune control for maximum REL PWR on the HA-14
Amplifier meter.
The reason i went through the tune up is to show that you only use two
knobs, band switch and tune control. The matching AC supply is the HP-24
and the matching DC supply is the HP-14.
I have used it mobile and except for replaceing the tubes (30 years old
original tubes) i have had no troubles with the HA-14 amplifier or the
DC and AC power supplies. If you
can find one it is still one of the best tube amps for mobile going. I
am also useing the HA-14 with my Ten Tec Corsair II at home. (not for sale)
Mike (W6THW)
If you have any questions, problems, or suggestions about Reviews,
please email your Reviews Manager <mailto:productreviewsmaster1@eham.net>.
<http://www.eham.net/ads/click.php3?bannerID=178>
NJ0IP wrote:
>This is a long shot, here.
>
>
>
>Does anyone have a Heathkit HA14 Linear Amp (or the manual) and if so,
could
>you please email me the size and weight of the device.
>
>I'm interesting to know if it can fit as carry-on baggage in an airplane.
>
>
>
>TNX
>
>
>
>73
>
>Rick
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|