TenTec
[Top] [All Lists]

Re: [TenTec] Orion and UPDATE mode.

To: "Steve Baron - KB3MM" <SteveBaron@StarLinX.com>,"Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion and UPDATE mode.
From: "Kirby Van Horn" <k7ec@sbcglobal.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 3 Jul 2005 21:18:43 -0500
List-post: <mailto:tentec@contesting.com>
But then, "to err is HUMAN!!"

Kirby, K7EC


----- Original Message ----- 
From: "Steve Baron - KB3MM" <SteveBaron@StarLinX.com>
To: "TenTec List" <TenTec@contesting.com>
Sent: 03 July, 2005 15:42
Subject: [TenTec] Orion and UPDATE mode.


>I posted the original this morning
> "Sun Jul 3 08:07:59 EDT 2005
>
>
> Turned on Orion this AM and screen says Flash Update Mode?
>
> After about 4 power on's over an hour, the system did load?"
>
> I got a few replies that the recall key may have been stuck.
>
> Don't think it was stuck, but I have a Bencher paddle with a Lucite cover.
> It was very close to the rig, close enough that  a small movement towaard
> the rig would put pressure on whatever button it contacted.
>
> SO, not an Orion problem at all.
>
> WOnder how many Orion problems are also initiated by operator actions
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>