TenTec
[Top] [All Lists]

Re: [TenTec] ladder line

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] ladder line
From: jerome schatten <romers@shaw.ca>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 10 Jul 2005 09:59:08 -0700
List-post: <mailto:tentec@contesting.com>
NJ0IP wrote:
Hey guys, comparing a Gap Titan to a flat-top or a horizontal loop is
already an apples to oranges comparison.  The vertical is vertically
polarized and the two others are horizontally polarized.
For short haul (NVIS), both horizontal antennas are going to work better
anyway.

For long haul (transatlantic) you might just find that the GAP works better.
I've never had a GAP but I can assure you that my vertical dipole with just
6m (19 ft.) per side works 10dB better than my horizontal full size dipole
up 13m (40 ft.) for transatlantic work.  Both are fed with ladderline.

When I work local German hams, the vertical is about 3 S-Units weaker.


[...]

What about the fact that the lower element of Rick's vertical dipole fed with ladder line is, of course, closer to the ground? Does this constitute an unbalanced load? Would we then assume that Rick's feedline radiates?

I use a 30 ft rod on a tower fed with ladder line, the tower (30 ft.) as the other leg, with the same results as Rick describes. One would think (at least this one) that if feedline radiation was significant, the long haul gain of the vertical (take off angle?) would be impaired. But I see as Rick does, better than 10db over a cf Zepp to Europe/Asia and even the east coast on 20/30/40.

So, does it make any noticeable difference if the ladder line feeding these verticals radiates? Can this be modeled easily? Enqiring minds need to know.

Jerome - VA7VV
Vancouver

<Prev in Thread] Current Thread [Next in Thread>