TenTec
[Top] [All Lists]

Re: [TenTec] Corsair problem

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Corsair problem
From: John Merrill <johnn1jm@yahoo.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 7 Aug 2005 13:00:30 -0700 (PDT)
List-post: <mailto:tentec@contesting.com>
Also make sure the dummy plug is good. I have seen one
that was not a short or intermittent.

John N1JM

--- Douglas <sparks06524@yahoo.com> wrote:

> 
> 
> >From: "Bob Stephens" <bstephens1@mindspring.com>
> >To: <tentec@contesting.com>
> >Sent: Saturday, August 06, 2005 10:27 PM
> >Subject: [TenTec] Corsair problem
> 
> 
> > My Corsair display reads 9.1 followed by zeros 
> > on 160-20meters and 9 followed by zeros 0n 17     
> >
> through 10. It does not receive and turning 
> > the dial does not affect the frequency.
> > 
> > Any ideas?
> > 
> > Bob,
> > KB1CIW
> 
> Bob, In addition to the suggestions of others, check
> to make sure that the jumper plug is installed in
> the
> multi-pin molex socket on the rear. Two pins must be
> jumpered together to supply power to the PTO. This
> jumper is pulled when the accessory VFO is used.
> I wasted an hour troubleshooting a Corsair only to
> realize that the accessory dummy plug was missing.
> 
> 73,
> 
> Doug/WA1TUT
> 
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>