There are two phono jacks on the rear panel where a remote VFO connects.
When that VFO is not connected, there must be a jumper between the two
jacks.
73, Mike N4NT
----- Original Message -----
From: "Bob Stephens" <bstephens1@mindspring.com>
To: <tentec@contesting.com>
Sent: Saturday, August 06, 2005 10:39 PM
Subject: [TenTec] Corsair problem
My Corsair display reads 9.1 followed by zeros on 160-20meters and 9
followed by zeros 0n 17 through 10. It does not receive and turning the
dial does not affect the frequency.
Any ideas?
Bob,
KB1CIW
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|