TenTec
[Top] [All Lists]

Re: [TenTec] Paragon Question

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Paragon Question
From: Robert & Linda McGraw K4TAX <RMcGraw@Blomand.Net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 06 Aug 2005 22:24:48 -0500
List-post: <mailto:tentec@contesting.com>
Carl's comments are very correct.  One other difference is in the 100 KHz to 
1.7 MHz range.  The front end switching and attenuation does reduce the 
sensitivity on the Paragon II. Also the Paragon II memory will be retained 
after power is turned off.  The Paragon required a 9 V battery which was 
recharged by external power to hold the memory.  It was only good for about 
10 days without recharging.  After that, all memory and clock settings 
reverted to factory defaults.  And the Paragon II provides 10 Hz display all 
the time.  That feature required initialization on the Paragon.  The Paragon 
II has a different SLOW AGC time constant.  The Paragon SLOW AGC was quite 
fast but could be easily changed by changing a cap to 22 mfd as I recall 
(I'll look if anyone want to know.)

I'm sure there are other differences and improvements but these are the ones 
I can recall at the moment.

73
Bob, K4TAX


----- Original Message ----- 
From: "Carl Moreschi" <n4py@arrl.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, August 06, 2005 9:12 PM
Subject: Re: [TenTec] Paragon Question


> Ken,
>
> The Paragon II has band registers and a much nicer user interface.  It is
> much closer to the Omni VI in operation than the Paragon.  It also has a
> quiter synthesizer.
>
>
>
> Carl Moreschi N4PY
> Franklinton, NC
> ----- Original Message ----- 
> From: "Ken Brown" <ken.d.brown@verizon.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Friday, August 05, 2005 11:56 PM
> Subject: Re: [TenTec] Paragon Question
>
>
>> Hi Bob,
>>
>> I too have both a 585 and a 586 on my desk. I had intended to carefully
>> compare the two, and then decide which one of them to offer for sale. I
>> never seem to find the time to make my careful comparison. So I expect
>> that I'll be keeping the 586, because it has AM TX (actually SSB with
>> reinserted carrier) capability and the 585 does not. Is there any other
>> significant difference in capability or performance between the two
>> rigs? If you had to choose between two 585s, or two 586s, or the
>> combination that you do have, what pair would you choose, and why?
>>
>> Thanks,
>>
>> Ken N6KB
>>
>> >The 585 is a Paragon.  There is no such critter as a Paragon I.  The
> Paragon
>> >II is a 586.  I have both on my desk.
>> >
>> >73
>> >Bob, K4TAX
>> >
>> >
>> >
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>