TenTec
[Top] [All Lists]

Re: [TenTec] Voltages on 262G power supply

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Voltages on 262G power supply
From: "wlstroud" <wlstroud@bellsouth.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 25 Feb 2006 22:03:06 -0500
List-post: <mailto:tentec@contesting.com>
You should not turn the ALC on the Triton IV "all the way up".  The amount 
of ALC should be set so that the ALC light just winks on your voice peaks 
for whatever band you are transmitting on.
73,  Larry WB4WSA

----- Original Message ----- 
From: "Danny Shaver" <n5nbk@nortexinfo.net>
To: <tentec@contesting.com>
Sent: Saturday, February 25, 2006 6:14 PM
Subject: [TenTec] Voltages on 262G power supply


> Hello Ten-tec techies, I need some help!!
> I have a 262G power supply that I just got with a Triton IV.
> I am getting distorted SSB transmit reports when I turn the ALC up all the 
> way on all bands. It is fine when I put the  ALC at about 50%.
> The voltage out of the supply is 12.95 volts on receive. In transmit with 
> 50% ALC it drops to 12.5 to 12.67 volts, and at 100% ALC it goes to 12.24 
> to 12.35, depending on band. I am testing into a 50 ohm dummy load. What 
> do you think?? Thank you for your help in advance.
>
> Dan N5NBK
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>