Re: [TenTec] 2.031 QSK bug - this is not a bug

["Gene Henderson" <ghenderson@insightbb.com>]

This happened to me also. Radio was in the receive mode but the centurion 
amp was indicating that it was transmitting as the transmit light was on and 
I was seeing plate current. I have reloaded the 2.31 software and the 
problem has left for now.   Gene WB9HLA
----- Original Message ----- 
From: "Ron Castro" <ronc@sonic.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, March 03, 2006 4:49 PM
Subject: Re: [TenTec] 2.031 QSK bug - this is not a bug


> The Ten Tec keying loop in the 425 is probably different than the 
> Ameritron.
> It is possible to hear with the linear in transmit, and in fact I did, 
> just
> not very well.  There is enough inter-electrode capacitance in the 
> 3CX800's
> to pass some signal back from the antenna to the input.  Sort of an
> attenuator with 2,400 VDC on it!
>
> Ron Castro
> Chief Technical Officer
> Results Radio, LLC
>
>
> ----- Original Message ----- 
> From: "Grant Youngman" <nq5t@comcast.net>
> To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
> Sent: Friday, March 03, 2006 11:30 AM
> Subject: Re: [TenTec] 2.031 QSK bug - this is not a bug
>
>
> > > Ron - if the QSK loop is open, the rig does not transmit.
> > His problem was that 2.031 seemed to "stick" with TX OUT pulled low 
> > keying
> > his amp even though the radio was in receive mode ??  (Is that even
> > possible?)
> >
> > I've been playing with mine using the loop on an AL-1200 on and off all
> > morning, seeing if I could duplicate it, but it's working without a 
> > hitch.
> > Grant/NQ5T
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec