My apologies, guys, I'm still running 2.055. Intended to load .056 but
haven't done so...may not if this is persistant.
I do not see this with 2.055. Buck, maybe you want to revert and see if the
problem persists.
Larry, N0XB
----- Original Message -----
From: "Barry Gross" <barry.n1eu@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, March 27, 2006 7:20 PM
Subject: Re: [TenTec] Orion Aux Audio output
> On my v2.056 Orion, the aux I/O "line" outputs definitely vary (almost
> linearly) with the main/sub af controls.
>
> 73,
> Barry N1EU
>
> On 3/28/06, Larry Menzel <retire@means.net> wrote:
>>
>> Hi, Buck,
>>
>> Well, I"m running RTTY with 2.056, with no problem, using the AUX I/O. I
>> set the volume to the program with the volume control for the soundcard.
>> The front control has no function on the I/O. Are you sure you have the
>> TX
>> Audio Source in the SSB menu set to AUX and not MIC or BOTH? Then pull
>> up
>> in Windows START>All Programs>Accessories>Entertainment>Volume Control
>> and
>> make sure your LINE IN is enabled, or easier yet just click on the volume
>> control in the lower right of your monitor. If you're hooked up
>> correctly,
>> LINE-IN will control the volume to the soundcard from the AUX OUT plug on
>> the radio.
>>
>> It is possible that you're simply using the sound from the speaker
>> through
>> your microphone to drive the software, because the TX Audio Source is set
>> to
>> mic or both.
>>
>> Hope this helps...or call me at 952 212 2664
>>
>> Larry, N0XB
>>
>>
>> ----- Original Message -----
>> From: <K4IA@aol.com>
>> To: <tentec@contesting.com>
>> Cc: <ditsnbits@tentec.com>
>> Sent: Sunday, March 26, 2006 11:27 PM
>> Subject: [TenTec] Orion Aux Audio output
>>
>>
>> >I have been trying to get back into digital modes and notice that the
>> audio
>> > output from the AUX I/O connector pin 4 seems to depend on the volume
>> > control
>> > instead of being a line out as described in the manual and as it
>> operated
>> > prior to ver 2.
>> >
>> > This is maddening because it means you have to turn up the volume and
>> > listen
>> > to the warbling. Before you could turn down the volume and just watch
>> > the
>> > screen.
>> >
>> > Anyone else notice this?
>> >
>> > K4ia "Buck"
>> > Fredericksburg, Virginia USA
>> >
>> > _______________________________________________
>> > TenTec mailing list
>> > TenTec@contesting.com
>> > http://lists.contesting.com/mailman/listinfo/tentec
>> >
>> >
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|