TenTec
[Top] [All Lists]

Re: [TenTec] Problem: Please confirm Orion II Radios

To: "Carl Moreschi" <n4py@arrl.net>, "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Problem: Please confirm Orion II Radios
From: <n4zz@bellsouth.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 3 Apr 2006 06:38:40 -0500
List-post: <mailto:tentec@contesting.com>
My Orion with version 2.056 fails in this scenario.

following steps:

1) Set NB to 2
2) Set NR to 2
3) Turn on manual notch and it fails

I tried some different nrs and it did not fail.

Don n4zz
----- Original Message ----- From: "Carl Moreschi" <n4py@arrl.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, April 02, 2006 10:57 PM
Subject: Re: [TenTec] Problem: Please confirm Orion II Radios


My OII does fail in this scenario. I just did a battery reset followed by a
master reset and it still fails.

My fails with just 3 steps:

1) Set NB to 2
2) Set NR to 2
3) Turn on manual notch and it fails.

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message ----- From: "Douglas Shock" <douglas.shock@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, April 02, 2006 11:27 PM
Subject: Re: [TenTec] Problem: Please confirm Orion II Radios


Phil,
Mine did the same. Do a abttery reset, then a master reset...the problem
never occured again

On 4/2/06, AI4DQ@aol.com <AI4DQ@aol.com> wrote:
>
> Version 2.032 software
> When operating my new Orion II this am Had terrible Noise with NB set > to
> 2  ,
> NR 3, Notch on and the SP set 3 and sweep on  I then went notch
> C  position
> rotating the Down from 1000HZ  when I get past 900HZ  I lose  audio and
is
> replaced with crackling sound The only way to restore the audio is  by
> turning the
> radio off and on a reset is not required. I would like others to
confirm,
> And I have one other owner confirm(WB4QDA) this Bug. and would
> like  everyone to
> confirm this. I tried others setting but the NB has to be on and the > NR
> has
> to be on as well as Notch.
>
> Phil AI4DQ
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


<Prev in Thread] Current Thread [Next in Thread>