Oof.. 250 Watts on SSB and 100Watts on CW... Didn't notice that. Thanks for
the catch. Guess I should check out the B&W.. It'll handle legal limit.. (I
can only do 500 Watts SSB and about 400 CW right now anyway)
Mike Hyder -N4NT- <Mike_N4NT@charter.net> wrote: the vee beam isn't rated for
qro.
73,
Mike N4NT
----- Original Message -----
From: "Dave Tipton"
To: "Discussion of Ten-Tec Equipment"
Sent: Tuesday, April 04, 2006 11:04 AM
Subject: [TenTec] Vee Beam
> Anyone here actually using the Vee Beam that is being offered on TenTec's
> site? I see that B&W also offers an end fed version that is similar.
> Just curious to see if anyone has an opinion about the design. :)
>
> After watching my push up mast snap this weekend, about 4 feet below the
> thing would have been guyed, and my MA5B taking a header into the ground,
> I'm searching for slighly less wind load options for now until I decide
> about putting a tower up. Great pictures of the event are available at
> http://blog.360.yahoo.com/blog-Dse6wvI1aaLHpzblehQs0wQ-?cq=1&p=32
>
>
> Dave, W3DMT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|