Typically corrosion in the counter and display driver connections. TenTec
service can give you a "hand written service sheet" to use to open up the radio
and correct the problem.
Best regards,
Gary - AB9M
CSM(r) G.L.Huber
9679 Heron Bay Road
Bloomington, Illinois 61704
(309)662-0604
www.csm-gh.com<http://www.csm-gh.com/>
csm-gh@www.csm-gh.com<mailto:csm-gh@www.csm-gh.com>
gary.huber@us.army.mil<mailto:gary.huber@us.army.mil>
wm@fifthinfantrydivision.com<mailto:wm@fifthinfantrydivision.com>
National Webmaster for The Society of the Fifth Division
www.societyofthefifthdivision.com<http://www.societyofthefifthdivision.com/>
----- Original Message -----
From: lw3ewz<mailto:lw3ewz@speedy.com.ar>
To: tentec@contesting.com<mailto:tentec@contesting.com>
Sent: Tuesday, April 11, 2006 9:31 PM
Subject: [TenTec] omni d series c display problem
Dear friends
i love this rig... but i have a problem
I need te solution at my display problen in my omni d series c
The display look 1.000 in 7 mhz band. 91.000 in 10 mhz, 09000 in 14 mhz and
21 mhz and sudenly the display works fine
what is the problem? and what is the fix or solution?
Sometimes the display works fine and sudenly works bad again..
thanks in advance
Gustavo A. Andrada
lw3ewz
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.375 / Virus Database: 268.4.0/304 - Release Date: 07/04/2006
_______________________________________________
TenTec mailing list
TenTec@contesting.com<mailto:TenTec@contesting.com>
http://lists.contesting.com/mailman/listinfo/tentec<http://lists.contesting.com/mailman/listinfo/tentec>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|