TenTec
[Top] [All Lists]

Re: [TenTec] Ver 2.033

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Ver 2.033
From: "Ron Castro" <ronc@sonic.net>
Reply-to: Ron Castro <ronc@sonic.net>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 30 Apr 2006 00:16:15 -0700
List-post: <mailto:tentec@contesting.com>
I noticed low power when I first tried AM in the new version, but after a 
few minutes it popped back up.  Another odd thing is that it operates 
different on 10 meters than on 75.  I checked it briefly on other bands, and 
I found that it want to make 50 Watts on 160-20, but 25 Watts on 17-10.  Go 
figure!

Ron N6AHA


----- Original Message ----- 
From: "Grant Youngman" <nq5t@comcast.net>
To: "'Ron Castro'" <ronc@sonic.net>; "'Discussion of Ten-Tec Equipment'" 
<tentec@contesting.com>
Sent: Saturday, April 29, 2006 11:21 PM
Subject: Re: [TenTec] Ver 2.033


>> I have noticed that the AM works different in that the power
>> output is now about 50 Watts, and does not change as the PWR
>> control is reduced from 100% to 50%.  Below that, the ALC
>> light comes on and the audio starts getting distorted with
>> serious downward carrier shift.
>
> You're doing better than I am :-(
>
> With PWR set to 100 I get a maximum carrier output of about 5 watts, with
> modulation peaks to 20.  There is no ALC action at normal levels.  The
> signal sounds ok, but that's not nearly enough power to drive my amp.
>
> With PWR set in the 1-5 range, ALC kicks in and the signal becomes very
> distorted.
>
> This is the second time that AM transmit has been broken in the process of
> tweaking something else.  It's been rendered useless once again.
>
> Grant/NQ5T
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>